Federal · FMVSS No. 213a, child seat side-impact standard
New federal child car seat side-impact standards start Dec. 5, 2026: which seats are covered, and parents do not have to replace existing seats
Compliance date Dec. 5, 2026
Free. Nonpartisan. Unsubscribe anytime.
The short version
- Starting December 5, 2026, most portable child car seats recommended for children in a weight range that includes 40 pounds, or a height range that includes 43 inches, must meet NHTSA's side-impact standard, FMVSS No. 213a. Car beds, harness-only restraints and qualifying school-bus-only restraints are exempt.
- Parents do not have to replace a seat already manufactured before that date just because the new standard takes effect. December 5, 2026, is a manufacturer compliance date for newly made seats. Federal safety standards apply to equipment whose manufacture is completed on or after the relevant date, and the manufacturing-and-sale law does not require owners to replace existing seats.
- South Carolina's own child-restraint law still requires children under 8 to be secured in the rear seat in the type of seat that fits their age and size, with limited exceptions. A seat that met NHTSA's physical standards at the time it was manufactured is sufficient under that state law.
- A companion federal standard, FMVSS No. 213b, updates frontal-impact tests for child restraints manufactured on or after December 5, 2026. Manufacturers may comply with the new standards early.
- Status
- Final federal standard. NHTSA set the revised compliance date for FMVSS No. 213a as December 5, 2026. Optional early compliance is permitted. South Carolina's child-restraint law (S.C. Code 56-5-6410 and the sections around it) is current law.
- Official source
- NHTSA final rule delaying FMVSS No. 213a compliance to December 5, 2026 (91 FR 57265, FR Doc. 2026-18380)
49 CFR 571.213a, Child restraint systems—side impact protection
This explainer does not take a side. It describes the federal side-impact standard for certain child car seats, using NHTSA’s final rules and the Code of Federal Regulations, and how that standard connects to South Carolina’s child-restraint law.
What changes on Dec. 5, 2026
The National Highway Traffic Safety Administration (NHTSA) created Federal Motor Vehicle Safety Standard (FMVSS) No. 213a, “Child restraint systems—side impact protection,” in a June 30, 2022, final rule. The original compliance date was June 30, 2025. (87 FR 39234, DATES) In a Sept. 9, 2026, final rule, NHTSA delayed that compliance date to December 5, 2026. Optional early compliance is permitted. (91 FR 57265, DATES)
The standard’s purpose is to reduce the number of children killed or injured in motor vehicle side impacts. A child restraint subject to 213a must also meet the applicable requirements of the main child-restraint standard, FMVSS No. 213. (49 CFR 571.213a, S1–S2)
Which seats the standard covers
FMVSS No. 213a applies to add-on (portable) child restraint systems that are recommended for use by children in a weight range that includes weights up to 18 kilograms (40 pounds), regardless of height, or by children in a height range that includes heights up to 1,100 millimeters (43 inches), regardless of weight. (49 CFR 571.213a, S1, S3) A seat is not taken out of the standard just because it can also be used by a larger child, if the manufacturer’s recommended range includes those weights or heights.
The standard does not apply to:
- car beds (restraints that position a child lying down on a flat surface),
- harnesses (a pelvic and upper-torso restraint made mainly of straps or webbing, without a rigid seating structure), and
- school bus child restraint systems (add-on restraints, including a harness, manufactured and sold only for use on school bus seats and labeled as the standard requires). (49 CFR 571.213a, S3 and S4) (91 FR 57265)
The 2026 rule also made related changes, including exempting school bus child restraints from the side-impact requirements (with specified labeling) and changing which test dummy is used for some forward-facing seats. (91 FR 57265) A companion standard, FMVSS No. 213b, updates frontal-impact child-restraint requirements and applies to child restraint systems manufactured on or after December 5, 2026. (49 CFR 571.213b, S3) (91 FR 57265, DATES)
Do parents have to replace existing seats?
No. The December 5, 2026, date is a manufacturer compliance date for newly made seats. Official federal sources do not require parents to replace a seat already manufactured before that date simply because the new standard takes effect.
- Federal motor vehicle safety standards in this part apply, according to their terms, to items of motor vehicle equipment “the manufacture of which is completed on or after the effective date of the standard.” (49 CFR 571.7(a))
- NHTSA’s 2026 final rule sets “the revised compliance date for FMVSS No. 213a” as December 5, 2026, and permits optional early compliance. (91 FR 57265, DATES) In describing an earlier, temporary pause on enforcement, NHTSA referred to the standard’s applicability “for CRSs produced on or after June 30, 2025.” (91 FR 57265 (citing 90 FR 28909))
- Federal law generally prohibits manufacturing for sale, selling, offering for sale, introducing or delivering for introduction in interstate commerce, or importing a motor vehicle or item of motor vehicle equipment that does not comply with an applicable standard and is not properly certified. It does not require the owner of a seat already manufactured and sold to replace it when a later standard takes effect. (49 U.S.C. 30112)
Some manufacturers were allowed to, and may have, certified seats to FMVSS No. 213a before December 5, 2026. A seat sold after that date might still have been manufactured before the compliance date. The manufacture date, not the purchase date alone, is what the federal compliance date turns on. Parents should still follow the seat manufacturer’s instructions, check for recalls, and observe the manufacturer’s stated useful life. Those are separate from whether 213a requires a replacement.
How this connects to South Carolina law
South Carolina has its own child-passenger law, separate from the federal manufacturing standard. A driver of a passenger car, pickup truck, van or recreational vehicle who transports a child under eight on the State’s public streets and highways must properly secure the child as follows: (§ 56-5-6410(A))
- Under 2: in a rear-facing child passenger restraint system, in a rear seat, until the child exceeds the height or weight limit of the system being used. (§ 56-5-6410(A)(1))
- At least 2, or under 2 who has outgrown the rear-facing system: in a forward-facing system with a harness, in a rear seat, until the child exceeds that system’s highest height or weight requirements. (§ 56-5-6410(A)(2))
- At least 4 who has outgrown the forward-facing system: in a belt-positioning booster in a rear seat, used with both lap and shoulder belts (not a lap belt alone), until the child can meet the adult-belt fit rules in item (4). (§ 56-5-6410(A)(3))
- At least 8 years old, or at least 57 inches tall: may use an adult safety belt if it fits properly: the lap belt across the thighs and hips (not the abdomen), the shoulder belt across the center of the chest (not the neck), and the child able to sit with back straight against the seat back and knees bent over the seat edge without slouching. (§ 56-5-6410(A)(4))
- Medical needs: with written documentation from the child’s physician, advanced nurse practitioner or physician assistant, a child who cannot use a standard system may be transported in a system designed for those medical needs. (§ 56-5-6410(A)(5))
If the vehicle has no rear seat, or if all rear seating positions are occupied by children under eight, a child under eight may ride in the front seat if properly secured in the appropriate restraint or booster. (§ 56-5-6420) The article does not apply to taxi drivers, emergency-vehicle drivers in an emergency, church, day care and school bus drivers, public transportation operators, or commercial vehicles. (§ 56-5-6440) A violation is a fine of not more than $150, which the court must waive if the person, before or on the appearance date, shows evidence of getting a qualifying child restraint system. A violation is not negligence in a civil case. (§§ 56-5-6450, 56-5-6460)
For purposes of the state law, “any child restraint system of a type sufficient to meet the physical standards prescribed by the National Highway Traffic Safety Administration at the time of its manufacture is sufficient to meet the requirements of this article.” (§ 56-5-6410(A)) So South Carolina law looks to the federal standards that applied when the seat was made. It does not require a parent to replace a seat that met those standards at manufacture simply because NHTSA later added side-impact testing for new seats.
Current status
FMVSS No. 213a is a final federal standard. Its revised compliance date is December 5, 2026. Optional early compliance is already allowed. (91 FR 57265, DATES) South Carolina’s child-restraint statute (Article 47 of Chapter 5, Title 56) is current law.
Get the next explainer in your inbox
South Carolina and federal laws, explained in plain English. One email a week: what changed and what it means for you. Confirm your address and get the free South Carolina 2026-27 Law Guide (PDF).
Free. Nonpartisan. Unsubscribe anytime. We'll email you a link to confirm. Privacy policy
Every statement above is drawn from the official source text linked here; section references are shown in grey. This is a plain-English summary, not legal advice. Spot an error? Tell us.